Not being able to update the firmware of the Netgear router can really leave a user frustrated as it disables him or her from enhancing the performance of the device. Are you also not able to update the firmware of your device via routerlogin.net? If your answer is yes, it recommended that ask yourself these questions:
- Is your Netgear router getting an adequate power supply?
- Do the router and modem have a stable connection?
- How far your networking devices placed from each other?
- Did you use the correct login credentials to log in to your device?
If the answer to any of these questions isn’t what it needs to be, then it recommended that you learn how to fix the Netgear router firmware update failure issue by following the troubleshooting hacks given in the below section.
[Fixed] Netgear Router Firmware Update Failed
- Change the Power Socket
Perhaps you did not check the wall socket before plugging your Netgear router into it due to which you got stuck with the Netgear router firmware update failure issue. You can’t deny that an adequate power supply needed in order to execute any process.
Therefore, to take care of this problem, it recommended that you plug your Netgear router into some other wall socket. Once that done, try to update the firmware of your device via http://www.routerlogin.net and check if the Netgear router firmware update failure issue has gotten resolved or not. If not, go through the 2nd hack.
- Verify the Cable Connection
Did you make the mistake of connecting your networking devices with the help of a wireless source of connection? Well, now you know what forced you to face the Netgear router firmware update failure issue.
To troubleshoot it, you need to switch to another source of connection. In simple words, use an Ethernet cable for the connection. If this helps you out, share your feedback with your fellow readers via the comment section.
- Reduce the Distance
Another common reason behind the Netgear router firmware update failure issue too much distance between the networking devices. You can easily reduce it by pulling your devices closer. Simply unplug the router from the existing socket and plug it into the one located near the existing modem.
- Use the Correct Login Credentials
Last but not least, check the credentials that you have used to connect your devices. Are they correct or do they need to corrected? Whatever the answer might be, it suggested that you enter the www.routerlogin.net setup password and username again.
After clicking on the Log In button, check if the Netgear router firmware update failure issue has bid farewell to you. Got no luck? Do not make another mistake by stopping reading this article.
- Perform Factory Default Reset
Did none of these hacks were helpful to you? Well, the time has come for you to access the perform factory default reset. Resetting your device requires you to locate and press the reset button. Do not forget to hold on for some time.
Waiting really important as, without enough of it, your device will not able to properly get restored to its default mode.
After resetting your device, refer to the user manual for the instructions to set it up. If you want to do Netgear N300 setup, you will find the steps regarding it there too.
Wrap Up
In no time, you will be able to troubleshoot the Netgear router firmware update failure issue by following the troubleshooting hacks mentioned in this post. Which was the hack that helped you out the most? Do share it via the comment section.
